Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello ,
i cannot access to my wlc via GUI , even it's configured on the CLI
I tried to follow the workaround provided in previous topics but i couldnt because i don't find "crypto pki trustpoint TP-self-signed" in show run even after running ip ht...
Hello ,
i i have this error message on ISE while connecting :
5436 RADIUS packet already in the process
does anyone know how to terminate a session , so the endpoint can be authentifacted ? is there any workaround for this ?
ISE Version : 3.1.0
T...
Hello ,
I have several APs getting dropped from wlc 9800 ( version : 17.3.6 ) with the error message : DTLS session closed for AP, cause: DTLS server session error
could you please advise what could be the problem
Hello ,
I have one access point with operations status down ( slot 0 & 1 ) .
i've checked the regulary domain , and it's supported
i have this message from the wlc : Radio is disabled. Turn ON radio to enable CleanAir functionality
access point :...
Hello ,
I have access point 1852I , following Cisco adivice i should have the image "ap1g4-k9w8-tar.153-3.JPJ9 " on it so it can joing my wlc ( 17.3.6 : 9800 ) .
i have tried to copy the file on USB on plug it to my access point and boot by using : ...
Thank you @Mark Elsen for your feedback , i tried to upload the file to https://cway.cisco.com/wireless-config-analyzer/ , but i got the same initial page ( see attachement ) .
the file is in txt format .
Hello Flavio ,
Thanks for your quick feedback ,
yes , the print is related to the port switch where the AP is connected .
no power is consumming even the power inline is on auto .
it didnt work when i plugged the AP directly to my laptop , should have to pass by a switch to perform the connectivity .
Thank you Flavio for your support !!
