I know this has been asked previously, but I've not yet seen any answers...   When implementing mac based port security via sticky macs or static macs on an interface how can we allow our Fluke and Netscout devices to test ports on our network?  We c...

So we have two 500Mbps circuits that are both /27's from our ISPs and they are both setup the same as follows: 1.  cable from the ISP router goes to a 2960x, 2960x has no config on port from ISP 2.  2960x port with no config goes to an Ecessa Powerli...

Can LACP priority help to make PO31 the active etherchannel over PO30 in my scenario? Image attached. Both LACP are currently setup with default priorities. Thanks! Dan