Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys, can anyone help clarify the uses and differences of AP-manager interface and manager interface? From boson exsim the explanation states that manager interface is for L2 communication between WLCs and APs and AP-manager interface is used for ...
Hello, does anyone know how the router derive the interface id for loopback interfaces if I were to use eui-64 format? Since loopback interfaces don't have a mac address. Thanks in advance!
Hello experts!I am experimenting with etherchannel and dtp but ran into a problem while trying to configure them for 2 switches. I first connected both switches on interface f0/23 and f0/24 using crossover cable, then bundled interfaces f0/23 and f0/...
Hi Flavio, thanks for the reply.Is it correct to say that if I were to create an AP-manager interface, that interface will be used to terminate CAPWAP control and data tunnels? And once the data reaches the WLC from LAP, it will be mapped to VLAN fro...
Thanks everyone for the help. I think I found the answer to my question here: https://networkengineering.stackexchange.com/questions/74281/eui-64-on-a-loopback-address However I still don't quite understand how it derives the interface id
Are you saying that I need to assign an ipv6 address to the loopback interface first then use eui-64 command to generate the eui-64 format of the ipv6 address? Doesn't that defeat the use of eui-64 of autoconfiguring ipv6 addresses? Can't I use ipv6 ...
