Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,
I would like to inquire about Cisco's Enhanced Warranty Policy.
According to the policy defined in https://www.cisco.com/c/en/us/products/warranties/warr-eltd-life-hw.htmlI understand that the RMA of Cisco's equipment is guaranteed until L...
Hello All,
I would like to know the clear difference between SNT(SmartNet) and SSSNT(Solution Support).
As far as I know, the biggest difference is that SSSNT supports 'compatibility between these models', but I don't understand what this means.
Does...
Hello all,
I am in sales handling SD-WAN solutions.Therefore, I am leaving an inquiry because I have some questions regarding SD-WAN.
I understand that when configuring SD-WAN, it is implemented by configuring the fabric on the controller. However, i...
If i select one of the two SKUs below in the SD-WAN License, i can't select the other.
Also, it seems like there are different levels of service that can be selected depending on the two SKUs, so I'm curious what the difference is between the two.
Ci...
As far as I know, looking at SD-WAN's DNA licensing system, if you use it without a license, there is a bandwidth limit of 250MB regardless of equipment performance.Additionally, I understand that if you allocate DNA License Tier 0 or Tier 1, you can...
Hello Leo,
So, under the Enhanced Limited Lifetime Hardware Warranty, can I get an RMA processed regardless of whether the equipment is Smartnet or not?
Regards.
Hi Kanan,
This question was asked to check whether it was possible to change the tenant as it was configured with single tenant in mind at the beginning of construction, but since multi-tenant operation was already required (if configuration changes ...
Then, finally, is it possible to change a controller that has already been configured as single tenant to multi-tenant? (Without disruption to service)
I understand that MSP can be configured in a multi-tenant format.
However, I understand that there are eligibility requirements for MSP. Is that right?
Then if the user is not an MSP, is there any way to configure it?
Yes, it was helpful.The reason I asked this question was because I needed a clear reason to purchase a license, and I think that was the answer.
Regards.
