Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Example:I have 3 SSIDs for Wireless in a 3 story office bldg.All 3 SSIDs will broadcast on all APs and roaming will take place between floors.I have a single subnet of 192.168.99.0/24 to work with192.168.99.0/25 gives me 124 useable hosts192.168.99.1...
I am still new to Meraki so I have a very basic question.When stacking C9300 switches, do you go into the local status page and assign IP address info and then the entire stack uses that same IP address, or do you need to assign a different IP addres...
When trying to click on any switch to manage it, the page loads but then reloads and it does this every 2 seconds and only way to get out of the loop is to close out site.I have tried clearing cache, using different browsers, using old version, using...
From the FPR1140, I can successfully authenticate both of our DUO Auth Proxy servers (RADIUS) by using the command: test aaa-server authentication DUO_VIP host 192.168.XXX.XXX.Use show run aaa-server command to get your actual aaa-server name and add...
@spaladug is there an updated list of URLs to add to the firewalls? I tried once again this morning on my mobile hotspot and it is working as it should.
Thanks @roland.hollatz1 for sharing this. I tried again this morning on my mobile hotspot and all pages now work as they should when I am connected that way.The deleting/adding my admin account on the Meraki portal fixed the switches pages but did no...
I have tried old version and the new version and they both do the same thing on the page reloads for me.I am currently on the new version.... for me to get back to old version, I click on Global Overview at far top left, then Monitor>Overview. Then f...
