Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear community,I have a LACP Portchannel configured on a Catalyst connected to a Nexus vPC.When I shutdown one Port of the vPC the connected port on the catalyst goes into lacp suspended state.That´s expected, as the port doesnt receiev any lacp pdus...
Hello guys,i have a real simple setup to play around with ACLs. See AttachmentI want to deny icmp from 10.52.84.11 to 10.52.4.11ACL:ip access-list ETH_SPSstatistics per-entry10 deny icmp 10.52.84.11/32 10.52.4.11/32interface Vlan15ip access-group ETH...
Hi guys,
I want to accomplish a conditional
default route
injection into OSPF .
An
ip sla
reachability configuration is pinging a host in the internet.
If this fails the
default route
injection should be withdrawn.
I can´t figure out why this configu...
Hi Guys,
I have configured a simple
hsrp
setup.
Two routers in one
hsrp
group. ( see picture)
The timers are
default ( hello: 3 holddown:10)
When i
ping 8.8.8.8
from the VPC i don´t see any packet loss when the active role changes from Router 1 to R...
Hi guys,Thanks for this very interesting discussion, which helped me to undertsnd the different "default route" options with Meraki Auto VPN.But one thing is still unclear to me.Through a default route advertiesd by the hub MX the branch mx dashboard...
Hi,have you been able to successfully deploy a 9800-CL on Nutanix-AHV at the end?I understand that AHV supports .qcow2 as it´s based on KVM.I have to migrate a 9800-CL HA pair from Nutanix-VmWare to Nutanix-AHV and any experiences from the community...
Hi, thanks for your helpful information.I can reproduce the issue in a much simpler topology ( see screenshot)The portchannel is established properly.I am pinging 10.1.1.9 > 10.1.1.10When I shutdown Gi0/0 on SW7 the ping fails.The reason is that even...
Welcome.That´s the mentioned guide:https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus9000/sw/93x/nx-osv/configuration/guide/b-cisco-nexus-9000v-guide-93x/m_cisco_nexus_9000v_9x.html
Just for information.With this vIOS version the ACLs are working like expected:Cisco IOS Software, vios_l2 Software (vios_l2-ADVENTERPRISEK9-M), Experimental Version 15.2(20200924:215240) [sweickge-sep24-2020-l2iol-release 135]
