Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have a CUCM cluster with IMP and CUC, the site had a power outage.and then all server nodes have shown these alertsDo I need to rebuild all nodes again, or is there a workaround to eliminate these alerts?Regards
Hi,I hope this message finds you well. I am currently facing an issue with logging into the VM CUCM subscriber. It's worth mentioning that the CUCM Sub was functioning properly before an electric interruption occurred on the hardware appliance.The er...
Hi,I have a Cisco AIR 1131 access point(firmware is c1130-rcvk9w8-tar.124-10b.JA3), when i type cli command : sh ip int brthe following syntax appears : FastEthernet0/0 is up, line protocol is down! Please help me fix this error.Thanks in advance.
Hi,I have a Cisco AIR 1131 access point(firmware is c1130-rcvk9w8-tar.124-10b.JA3), and when I try to save any configuration, an error message appears: "NVRAM Verification Failed". Please help me fix this error. Thanks in advance.
HiI have a CUCM version 15.0.1.12900-234 SIP trunk connected to a Cisco ISR4451 router.The VoIP phones are managed by CUCM.There is a requirement to communicate with the PSTN via a T1/E1 module.There is also a requirement to communicate with an exter...
Hello,thank you for your feedback,Could you explain further, considering that in my AP the CAPWAP commands are not supported, whereas those of LWAPP are only acceptedBest regards
