Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I have experienced in Cisco 9300 switch without the IP routing command, the default route is functioning but the specific static routes not functioning. But the routes are adding to the configuration and the routing table. Could you explain t...
Hi All,
I need to know can we encrypt switch-to-host and switch-to-firewall traffic in Nexus 9000 switches using MACSec feature.
As well need to know the license which support MACSec in Nexus 9000.
Thanks
Hi All,
I need to have the proper understanding of the use of Native VLAN in the trunk switchport an Access point is connecting.
My current understanding is the AP can not read DHCP IP address via a tagged port (can not read 802.1Q packets).Therefor...
Hi All,I tried to onboard a C9300 switch to Meraki Dashboard. It was passed all the steps in the onboarding app but hanging in the onboarding step and looping the log "Waiting for device to be available". After analyzing the switch config with a succ...
Hi All,
I am using Cisco 9800-CL as the WLC and the Microsoft NPS as the Radius Server.
I need to know whether the same client can be authenticated from both the methods EAP-PEAP and EAP-TLS simultaneously. As a brief, user need to log in to the same...
@Rich R , Still I am having below doubt.
WMI is used by Access Points to communicate with the WLC. But for accessing GUI (Management purpose) in EWC AP why we need to make the Gi0 interface as WMI interface ?
Hi All,
With further studying and troubleshooting of the setup understood the below.
For functioning Static routes (there is a limit for static route count) and Default route no need to run "ip routing" command. For the inter-vlan routing need to run...
Executed the show run all command and not found the ip routing enabled. Without the ip routing enabled, when pinged the remote server in Site B connected to a C9300 switch, from the Site A switch (C9300),not worked. But ping worked to the SVI of the ...
