we have WS-C3750G-12S-E [c3750-ipservices-mz.122-35.SE5] and we are getting one C3750X, Can these two switches be stacked together ?would we have to upgrade or change the firmware on WS-C3750G-12S-E ? if yes what should be it. I already checked be...
Hello, We have a CISCO3945 router with IOS - (C3900-UNIVERSALK9-M), Version 15.2(4)M3 Would I be able to configure a client vpn on this router, What different type of vpn clients from cisco I can use, Please advise, Thanks,Aashutosh
Hi, One of the APs is reported to as 'keeps cycling from Blue, Green and Red'points to - ap location command invokedWhat does this exactly mean ? how do i identify which ap it is from controller. Controller model -5508AP model-1142Firmware - I am re...
Hello, I have seen this many at times, We usually configure our access points with static ip addresses for monitoring purposes,Many at times we have observed that an AP with static ip fuctional for a while, would take an ip address from DHCP. This t...
Hi,My requirement to use AP 1142 as an autonomous AP with 3 ssid/ 3 vlans,Unfortunately its not working, SSID 1 - ABC - 10.10.10.0/24SSID 2 - DEF - 10.10.20.0/24SSID 3 - GHI - 10.10.30.0/24 DHCP pools are configured locally, Clients can connect and i...
I agree I am completely depending on our onsite person, he unplugged the cable and seen the led go away on the AP and then he plugged it back in, he says it was green for a while and started blinking again, So lets say if I do show ap led-flash <ap ...
Thanks Ric, I managed to find out the AP, switch and switch port it is connected on - with onsite help. We powercycled italso did > clear all config from controller guiAP is functional and clients connected to it are fine. But the LED is still cycli...
As mentioned, I don't have any information about switch port or switch it is connected to, I was still wondering if something can be checked remotely on controller itself. Last option would be to involve someone onsite, Apart from that what the hell ...
And I know for a fact that if i reset these APs, they would go back working on static ip addresses.As we have faced this so many times with different clients