Hi Guys,Unable to download CTC for some of my older legacy ONS systems, wondering where I can get it from?Page loads and says: Cisco Transport Manager - Retirement NotificationThanks,Tom
I get an issue when trying to assign bandwidth to a policy-map for DSCP bandwidth.Config:!ipv4 access-list ACL_GOLD10 permit ipv4 any any dscp af23!class-map match-all CM_GOLD match access-group ACL_GOLD end-class-map! Error:!! SEMANTIC ERRORS: This ...
Trying to configure IS-IS for the underlay network for VxLAN and can't seem to form and adjacency.Can someone spot what might be causing my adjacency not to form?Spine:interface Ethernet1/1no switchportmtu 9216medium p2pip unnumbered loopback0isis ne...
Hi,I have an IOS-XR edge router with 2 equal cost static routes with an AD of 1.But one network Is only accessible via ISP2 and and all traffic seems to be going down the static route for ISP1. Am I missing anything.Please see photo and outputs attac...
IP routing command essentially turns the switch from a Layer 2 Switch to a Layer 3 switch.Layer 2 switches still use default-gateway in order to be able to manage the device in the network however if "ip routing" is enabled this still allows for mana...
I found a solution that worked for me.I bundled the 2 interfaces together to create a Bundle-ether and created 2 sub-interfaces on the bundle.I then created a trunk on the receiving interfaces on the switch: interface Bundle-Ether1!interface Bundle-E...
I found this article:Trying to set a key-string for IS-IS using HMAC-SHA256 but keep getting an error...https://media.defense.gov/2022/Feb/17/2002940795/-1/-1/1/CSI_CISCO_PASSWORD_TYPES_BEST_PRACTICES_20220217.PDF