Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, we are using 9200L switches and our Windows 11 machines are experiencing the below issue. Windows 10 machines are fine. So I'm not sure if it's totally related to Windows 11 or if the switch port configuration needs to be adjusted. The Windows...
Hi, we have several Cisco 3850 switches (WS-C3850-48P) that are all experiencing the same issue with various devices. We have printers and laptops that take several minutes to obtain an IP address. Sometimes the radius server sees the devices succe...
After configuring the switch and switch port, our laptop is connecting to the network but there are no logs confirming the the successful authentication in our NAC. Is there something wrong with the configuration? We would like to configure a range...
Hi, we are currently rolling out a NAC product in our production environment and are running into a lot of devices that after configuring the switchport don't attempt to do any kind of communication on their own. Therefore, the NAC is unable to see w...
Hi,I am trying to change the IP address on a Catalyst 2960G. I reset the switch and the default IP is 10.0.0.1, which pings and I can access it.I Telnet into the switch via Putty and enter the below commands:Switch#Switch#config terminalSwitch(confi...
Each switch is configured with its own DHCP pool. For instance, a switch located on a specific floor would be set up as follows: ip dhcp pool Desktops network 10.30.34.0 255.255.254.0 option 130 ip 10.50.0.21 10.50.0.20 10.50.1.21 default-router 10.3...
Hi Rodrigo,Thank you for the information. However, I am not using ISE so I'm not sure if that "device-tracking" feature applies here. We have various sites and this is the only site with these switches that are experiencing significant delays in re...
