About Weezy-F

Weezy-F · 05-26-2025

Hi All, I'm just newbie on cisco Wireless. We have guest users that can't connect to our guest wifi using the UN and PW we provided and when they login it was loading only. After some doing research I found this I set go to our WLC and set the NAC se...

Weezy-F · 05-25-2025

We have an ISSUE on our GUEST WIFI we can generate a UN and PW but when the user connects on wifi , it loads on login login page only. I check the ISE logs and the user was able to authenticate. I did check some forums and it says I need to set the N...

Weezy-F · 05-06-2025

Hi All, We have a Cisco WLC KUL-WLC AIR-CT3504-K9 on our Europe site and we have a deffective Cisco Aironet 2800 Series AIR-AP2802I-K-K9 access points which is already EOL. I want to replace it but do you have any suggestion for a model that is alm...

Weezy-F · 04-09-2025

Hi All,I was working with our CCTV provider earlier, he tried to setup their CCTV camera and I can see the MAC of the CCTV on our access switch and I can see the IP address that I allocated for for CCTV on our Core switch. The problem is the CCTV its...

Weezy-F · 01-08-2025

Our Guest users are able to connect on WIFI. I was able to verify it successfully authenticated on our CISCO ISE and WLC is working properly. Is there a way that I can Reset the policy counters on CISCO ISE via CLI? Please let me know

Weezy-F · 05-26-2025

o I just found out that when I compare the settings of all of our WLC in APAC sites, the GUEST WIFI NAC Settings is set to ISE NAC. This will allow the users to enter the UN and PW once only and will automatically connect them. Also I notice the othe...

Weezy-F · 05-26-2025

I did send you a private message please check.

Weezy-F · 05-26-2025

Hi Haydn,So I just found out that when I compare the settings of all of our WLC in APAC sites, the GUEST WIFI NAC Settings is set to ISE NAC. This will allow the users to enter the UN and PW once only and will automatically connect them. Also I notic...

Weezy-F · 05-26-2025

We are using AIR-CT3504-K9

Weezy-F · 05-04-2025

It's resolved now. There's lot of miscommunication on this issue because on the past 2 weeks we are troubleshooting it via chat only no share screen and I couldn't get hold on the CCTV guy and our local IT to setup a meeting. Earlier I connected it ...

Member Since	‎09-12-2023 05:12 PM
Date Last Visited	‎05-27-2025 05:28 PM
Posts	49
Total Helpful Votes Received	1

User Statistics

User Activity

Guest wifi becomes OPEN after the NAC it set from NONE TO ISE NAC

OUR GUEST WIFI not ASKING for a Password

Cisco WLC KUL-WLC AIR-CT3504-K9 - AP replacement

CCTV can't see the mac address of our Cisco 9300 switch

Guest users connected on WIFI but no internet

Re: Guest wifi becomes OPEN after the NAC it set from NONE TO ISE NAC

Re: Guest wifi becomes OPEN after the NAC it set from NONE TO ISE NAC

Re: Guest wifi becomes OPEN after the NAC it set from NONE TO ISE NAC

Re: Guest wifi becomes OPEN after the NAC it set from NONE TO ISE NAC

Re: CCTV can't see the mac address of our Cisco 9300 switch