Why did Cisco remove WebVPN support on the 850 series platform in 12.4(6)T? I've deployed 850 series routers for small offices, and low and behold after the upgrade to 12.4(6)T. WebVPN is gone. It looks like they want you to buy an 870 so you can ...
Does CallManager support analog gateway features like (call waiting, call transfer, etc) off an FXO centrex line? If so, what CM version and what gateway features are required?I know that CME does...
I built a config to rate shape P2P traffic on my network to 30k/s. I thought it would be useful for people who are looking to limit peer-peer traffic inside their company. If you have any additions or other ideas, let me know.This is on a Cisco 175...
I am working on a fairly complex design for a financial services customer that has 17 branches with existing analog DID trunks to the PSTN and DID number assignemnts. I would like to maintain the existing DID trunks and numbers as they don't warrant...
While I was staying down in San Jose for the Operations Symposium this week, I was able to get an off-site phone working with CME over the Internet, giving me 4 digit and PSTN dialing from my home location. I took a 7905G with an H323 phone load and...
You should be able to use H.323 gateway and dial-peers to accomplish what you want to do. The AGM will run hybrid H.323/MGCP, check into "ccm-manager fallback-mgcp" and "call application alternate DEFAULT". The SRST reference should point to the SR...
The above post is not correct.You need to purchase the CCME feature license on the router if you are going to run it legally. Also, you will need to purchase CCME licenses on each phone that you plan to attach to the CCME system. Contact your resel...
Tom,Set your extension pattern in the telephony-service setup to "88707..." the three dots signify a 3 digit extension. So presuming I understand this, your full number would be:88707...Valid numbers would be:88707000to88707999Hope this helps. Scor...
Based on the information you've given - this is a Catalyst 6500 power supply and power switch blade problem. This is indicated by the fact that the 7970 sets did not reboot because they have local power adapters. 1. Check the power supply configura...
It is not TAC supported by Cisco, but it does work with a set of caveats. Please reference the following URL for more information:http://ciscogroups.anvi.com/cme/index.html#How_do_I_register_phones_to_CCME_overPat