Hello,What are the possibilities for configuring a WLC to authenticate WLAN users based on their Active Directory user account? Is this possible by setting up local EAP on the WLC?I’ am looking for a solution where there are no changes to the Domain ...
Hallo,In our company fiber optic ring network I would like to test what the bandwidth between each switch is. To test the individual parts of the network.Could someone recommend a tool for this, preferably freeware.Thanks,
Hello,I am replacing an Cisco 4006 with a Routing module. The replacement switch will be an stack of one 3750G and two 3750V2.The Routing module of the 4006 has 192.168.1.3 as IP address. And does some routing to two gateways. all traffic for network...
Hello,In the web-interface of the switch port Fe0/4 shows up orange an the description says that it is disabled.When I use the show interface fa0/4 command it says the port is up----------------------------------------------------------------FastEthe...
Hello,I am upgrading our company network switches and I used the Express GUI install to configure the switch with the IP settings and passwords.Are there any more settings I have to configure before deployment? Such as STP, or is this enabled by defa...
We are also thinking about implementing an open guest network. This network is open to connect to but when you connect to the internet you need to accept an agreement and login via a web page. Can this be done with the 2504 WLC?Also web-filtering on ...
So what are the other options if AD is not supported?And what is the difference with this manual? Because AD is used.http://www.cisco.com/en/US/products/ps6366/products_configuration_example09186a008093f1b9.shtml
Is there an explanation that the iperf test shows a lower result than an actual client to client file transfer?Also when I test the bandwidth over CAT6 cable and directly connected to an gigabit switch, iperf gets a maximum speed of arround 390Mbit/p...