Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have 4 multicast sources sending traffic each to two multicast groups, as follows:
10.65.190.1 -> 224.64.64.110.65.190.1 -> 224.64.64.510.65.190.2 -> 224.64.64.110.65.190.2 -> 224.64.64.5
The traffic enters the router via a VLAN interface con...
Hi, I'm wondering whether it's possible to read MROUTE MIB OIDs for the mroute table that belongs to a VRF (instead of the global RT). Currently, I can only see the OID for the global routing table.
I've looked in to the option to use SNMP Contexts, ...
Hi,
I would like to understand which IP Multicast routing capabilities (PIM variants) will be supported in the (very) long term future on the Catalyst 8200 and Catalyst 8300 router models with traditional networking (no SDWAN). Where could I get som...
Hi,
I have an issue upgrading a ASA 5515-X's ASDM version on the latest version of Windows 10.The launcher reports: "A newer version of the ASDM-IDM Launcher is available. To upgrade, click the "Upgrade Now" button".When I click this button, the late...
Hi,I have a fairly complex routing set-up with mutual redistribution between BGP and EIGRP. I would like to monitor any kind of change in the routing table, or the underlying databases (BGP table, EIGRP topology) by using SNMP (similar to monitoring...
Hello, I think I added the output of the 'show ip rpf x.x.x.x' in my initial post.
other outputs are here:
RTR#sh ip route 10.65.190.1
Routing entry for 10.65.190.0/25
Known via "static", distance 1, metric 0
Routing Descriptor Blocks:
* 10.32....
Hi, only the flows which are in the mroute table are effectively forwarded.
Indeed, both multicast sources are in the same subnet and ingress on this router via the same interface, i.e. Vlan1 (I also used Vlan11, but that interface is admin shut down...
Hi, I was obviously mistaken as I meant 4 flows instead of 4 sources. There are indeed 2 sources that each send traffic to 2 groups. I don't see traffic for the flows marked in red.
The output of the requested commands is as follows:
RTR# show ip pim...
