Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I hope someone can help me or point me in the right direction for a possible solution here. I'm currently working on a solution to terminate a new MPLS network. The connection is VRF within BGP. There are two VRF's coming in via BGP. These two ne...
Hi, hope someone can help with this. I am trying to establish a site to site tunnel between an ios router and a PIX 7.0(1). The ios router is 12.4(15)T7. At the IOS router side I have configured a static 1 to 1 NAT to translate the 172.31.x.x source ...
Hi, hope someone can help. I've been working on setting up access from some clients on the inside interface to a host on the dmz. I've been unable to get it working so far. The config is below.ASA Version 7.0(8)!enable password Bte2XWw78iXdJmqt encry...
Hi, hope someone can help with this one. I've integrated a UCM 6.1 with an MD110 via a Cisco 2821 QSIG E1, the 2821 is managed by the UCM using MGCP. The integration works fine and calls flow across the QSIG. I cannot however get Caller ID from the P...
Hi, I've got a problem with caller-id across a QSIG link. The QSIG connects an MD110 and Cisco 2800 H323 voice gateway. The PBX has caller id enabled and is sending digits across the link, when I enter in debug isdn q931 I can see the digits being re...
Hi Giuseppe,I'm having a couple of problems with this, I hope you can offer more advice. I have a single BGP process ID on the Cisco 3560X, in here there is an address family with the external/MPLS BGP neighbor for the VRF(I'm only bringing one VRF o...
Hi Jason, thanks for getting back to me. Been a long time since I looked at this one..Did you find the pin out diagram you had mentioned? Any help would be greatly appreciated.Thanks,Kenny.
Thanks for getting back to me. I've checked the config of the internet facing router and there is no port filtering. At present, I have VPN clients that can connect to the PIX for remote access. I still cannot see how the PIX is either not receiving ...
