Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We are having a setup something like this:PC=>2950=>2620=>7200=>NAS boxUsers are having intermittent slow response access files on the server. It is only file access which is slow. Apart from this, everything else seems to be normal.Do anyone has ...
Hello,We have a setup something like this:NewRouter (Gi0/0)===>(port 7/48)Core switch (port 5/48)===> (Fa0/0) OldRouterWe are in the process of turning a new circuit up through NewRouter. New circuit is a DS3 which is up and fine (per vendor it is cl...
Hi,Seeing the following error continously on one of the routers.%RCMD-4-RSHPORTATTEMPT: Attempted to connect to RSHELL from x.x.x.x Could some one suggest how to block this.Thanks in advance.Shashi.
Setup is something like this:Cat 4000 ==> 2950Management vlan: 255Config on 4000:set trunk 5/2 on dot1q 1-1005Config on 2950:int gig 0/1 switchport mode trunk!int vlan 255 ip address 10.1.1.1Problem:PCs connected to 2950 switches are able to access ...
Hi allI have 2 6500 series switches @ the distribution layer doin the intervlan routing for 1500 users..The access layer consists of 12 of 4500 series switches all dual homed to the 6500 switches.. The issue is that when i give a show cam dynamic o...
Hi Prem,Thanks for your response.There is no QOS enabled on our network. Surprizingly, we are having 2 spoke site facing this problem. And all other sites are fine.Any suggestions or expert advice is appreciated.Thanks and Regards,Shashi.
Hi,OldRouter has a 9M link which is carrying the traffic from the site. Now we are putting in the NewRouter with a 12M circuit on which we want the traffic to flow. To route traffic onto the new circuit, we are using the passive-interface command.. (...
Hi MarkYes there is a trunk between the two 6500 switches. the two switches act as a root switches for odd & even vlans respectively. For this reason i think i can see Mac addresses on both the trunk. Spanning tree is enabled...But is this a normal b...
