Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I suspect I am missing something easy.
Two Nexus 35K switches in Active/Standby HSRP mode work perfectly for all all network routing except for 1 VMWare host. The VMWare host has two 10GB vNICs connected to the pair of Nexus switches. Both vNICs ar...
I suspect I am missing something easy.
Two Nexus 35K switches in Active/Standby HSRP mode work perfectly for all all network routing except for 1 VMWare host. The VMWare host has two 10GB vNICs connected to the pair of Nexus switches. Both vNICs ar...
We have multiple VLAN's routed on a core Nexus switch. We want to change one of the VLAN's (172.20.50.0) to DHCP from static IP addressing and would like to put the DHCP server on our "infrastructure" VLAN (172.20.60.0) which is not the VLAN being sw...
I have a new C240 M4 server with MegaRAID 12GB SAS HBA. I have configured a bootable Virtual Drive (VD0) with 2 SSD's and a RAID 5 Virtual Drive (VD1) + global hot spare with 5 1TB SAS drives.
I installed ESXi onto VD0 without any problem, but the s...
I have a new C240 M4 server with MegaRAID 12GB SAS HBA. I have configured a bootable Virtual Drive (VD0) with 2 SSD's and a RAID 5 Virtual Drive (VD1) + global hot spare with 5 1TB SAS drives.
I installed ESXi onto VD0 without any problem, but the s...
Port Channel is not configured on the Nexus side - the two ports are configured as access ports allowing a single VLAN.
The vmNICs are configured as Active-Active no teaming.
We did disable one of the vmNIC's with no change to behavior.
Traceroute...
Earlier this week we configured VMWare in Active/Standby mode to track the switch configuration but the situation actually got worse. The switches themselves are in Active/Standby mode already.
Are you familiar with the C240 M4 VIC's? Do you know h...
I think that pretty much clinches it, but we will test shortly to see what settings we have access to.
I will keep this thread open for a while -- at least until we have our testing done.
Thanks again.
Thank you Mark.
I think that is what we want for the end state of this project, but say we install a new server on the infrastructure network and it doesn't give you a choice to choose DHCP or a static IP address during the installation (e.g. ESXi in...
I went ahead and rebooted. ESXi has booted so it looks like I have the answer to the last question.
Thanks very much, Wes. I can now hand this off to the VMWare admin. It is my first UCS server.
PS. Cisco docs could be a bit better.
PS2. Setting up...
