Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm actually wondering if PT 8.2.2 is actually lacks some feature or its just the PT distribution I installed? I installed it on my Linux, and from yesterday up to now I've got 2 issues.1 is the PBR which does not allow me configure the route-map, an...
So here is my topology. But I will not write each router's interface configuration, because I already put them in my .pkt file attached below this question. But I will show you my OSPF configuration for each router as following:1. router0router ospf ...
I've seen many discussion on this, I repeat the procedure but still does not work on my project.
1. I tried to configure
Router0
as following:
- FastEthernet 0/0: 192.168.1.254 255.255.255.0- Fast Ethernet 0/1: 192.168.10.2 255.255.255.0...
That's fine, I just realized that in Cisco PT only the 2811 supports the telephony-service, other routers don't have telephony-service.So different than GNS3 images or in real Cisco routers.