Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
what happens when you connect two different stacks (turned off) incorrectly together with stacking cables and then turn both on?
Unfortunately I can‘t test it myself currently and have not found anything on google.
Hi,
I remember when I had configured another interface on the ASA with a primary and secondary ip address (standby) I was able to connect to both ip addresses via ssh.
Now this interface is gone. There is only inside (called transit). I have added a ...
Hi,
I have configured two ISPs (WAN1, WAN2). VPN with anyconnect was already working for both ISPs. Today when doing final tests, VPN for ISP1 on WAN1 is not working anymore. ISP2 on WAN2 still works.
ASA log shows:
1 Starting SSL handshake with clie...
Hi,
provider 1 provides a /29 subnet with 5 useable IP addresses. NAT rule is in place so all five IP addresses can be used by the ASA.
But the question is, is only the first useable ip address of the /29 subnet available for anyconnect? I am asking ...
In a previous post I had a problem where the ASA or the rest of devices in the management vlan are accessable by VPN but not all at the same time (https://community.cisco.com/t5/network-management/can-access-hosts-in-management-vlan-either-or-asa-man...
Sure that‘s right. I mean kind of a security feature that prevents that as long as there is not default config when it‘s brand new.
I will have a look tomorrow and see how the situation is onsite.
Let‘s say we have stack A and B. Each stack has is‘s own working configuration. All switches are the same modell and firmware version.
Then you connect each stack together but you make the mistake and connect it as if it‘s one big stack together.
We have found the cause in cooperation with Cisco TAC.
We needed to configure a group URL in the tunnel group profile, i. e. vpn1.domain.com/TunnelGroupName
It's unclear why this group URL is not needed for the configured backup server in the anyconn...
