Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I made LAB using CSR1000V as PE and 3750 as CE , i configured RIP CE/PE, routing between them is working well, however redistribution is not working
PE configuration :
vrf definition vpn1 rd 100:1 ! address-family ipv4 route-target exp...
Hello,
We have Catlayst 6506, which is alreaday in end of life , we are looking if there is any way to to be upgrde , below the version
Version : 8.1(3)
Thanks ,
Hello,
I had a problem when I tried to connect switch cisco 2960S with DLINK converter.
When I connected the converter with a switch that has a Gigaethernet interfaces the connection has established.
but with switch interfaces lower than Gigaethernet...
Hello,
we have just deployed 2960 X switchs and we noticed that CPU is high reaching 29%, below the result of show cpu process
CPU utilization for five seconds: 29%/0%; one minute: 30%; five minutes: 30%
PID Runtime(ms) Invoked uSecs 5S...
Hello,
I have VSS configured between two 4500 X, connected using OM4 and SFP 10G-SR, i have the following message
%SFF8472-5-THRESHOLD_VIOLATION: Te1/1/1: Rx power low warning; Operating value: -11.2 dBm, Threshold value: -9.9 dBm.
Thanks in ad...
Hello Philip,
Thanks for your feedback,
as we have another catalyst switch 6509, we want to creat VSS between them, this is why we are looking for best solution ethier to pruchase another one or if it possible to upgarde from catos to IOS, below t...
HI,
Below the result of show version command
WS-C6506 Software, Version NmpSW: 8.1(3)
System Bootstrap Version: 7.1(1)System Boot Image File is 'bootflash:cat6000-sup2k9.8-1-3.bin'System Configuration register is 0x2102
Hardware Version: 3.0 Model ...
