Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Wizzle1,about your question:"Problem is that for all VPNV4 prefixes always AGG-01 is best route selected on PEs due to Lowest Router ID (other BGP attributes are same) and so all downlink traffic from PEs towards AGG follow just AGG-01."In other w...
Hi foysol_bgd,about your question:"Without modifying the RD values what is the best way to advertise both the routes from Route reflector to other PE devices."OPTION 1You can use add path capability, https://tools.ietf.org/html/rfc7911As you know BGP...
Hi samarjit dutta,I would do the following in order to check the operations:1- Connect CE1 not as vrf device, connect CE1 to PE1 in global scope. Do not enable mpls in this connection, ipv4 only2- At CE1 create static route to destination, 8.8.8.8, ...
Hi etiennevella,Elvin indicated practically all solutions. As there is LDP between Cat6500 I will try EoMPLS.Remember that all L2 frame will be encapsulated, thus MTU between Cat6500 must meet that requierement, 1500+L2 header+MPLS label(s). I indica...
Hi tyagi.v,There are many questions about your environment, but if there is BGP in place you can deploy BGP flowspec in order to mitigate some problems.If you know the flow details (L3/L4 information, addresses, port numbers, protocol, etc...) of the...
