Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Having a problem with a configuration of our guest network and our content filter (S170 IronPort). The 1841 has 3 interfaces. 0/0 is on the LAN side, 0/1/0 is connected to the Ironport, 0/1 is connected to the ISP. So we would like to redirect all tr...
We migrated a fax server that needed 8 ports (fractional T1) and we have it live running through our old PBX (in one T1 card and out another). We received a Cisco 2600 that has 2 T1 cards in it that seems it should be able to be programmed for the s...
We tested a webfilter as a transparent bridge for web filtering and it worked fine. When we moved it into production it worked fine for LAN traffic but our 6 WAN sites that connect to our main site for internet were not able to get out to the interen...
Need some advice on connecting 2 MPLS networks together from two different ISPs. The compnay I am working with is using AT&T MPLS and they aquired a smaller company using SBC MPLS. We want to connect the two networks together for the shorterm and eve...
It might be the missing priority on the second device. Although I know it should by default give the one device the priority of 100, you might want to enter it anyway. also did you try taknig the authenitcation line out of both sides? Another though...
Ok Rick, thanks for the insight. This project will probably be bumped to Jan. so I won't know until then if it is sucessfull but I will try it and let you know.
ok it is currently setup as the second scenario you outlined above. So in the config example I would use the 1700 part of the example:card type t1controller T1 0 framing esf linecode b8zs tdm-group 2 timeslots 13-24!controller T1 1 framing esf c...
The fax server is using a brooktrout fax board. I don't believe it needs an IP assigned. Would the router have the T1 traffic in the WIC and oit the ehternet interface to the fax server? Or would I need two T1Wic's in the Router?
The sample coonfig I have been looking at is using eBGP between ASBR's. Am I going down the wrong path?http://www.cisco.com/warp/public/105/interasvpn.html
