Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 6506-E with 720 Sup. I am trying to connect a server with HP 550SFP Nic to my 6506.If I plug the SFP from my server into my 6506 it will not link. When I plug that very same SFP into a 3750 it links fine. Makes me think that there is somethi...
Having a problem connecting servers with HP NC550SFP Nic's to Catalyst 6506.Have servers with NC550SFP Nic's and if I plug the SFP Patch cable into a 3750 or 2960 or any other switch (Connected to this same 6506) they link up and work fine. When I pl...
I am trying to figure out a way to make it so that my CiscoWorks will monitor snmp of my Aironet AP's. Problem is that AP's are controlled by 4400 Controllers and while I can get the necessary SNMP Strings onto the AP manually and get them into Cisco...
Thanks for the inputI finally figured out today that I had to set the following to get it to work.speed nonegotiatespeed 1000Once I did this they started linking correctly.
Defaulted the config on interfaceEntered switchportswitchport hostswitchport nonegotiateTested connections and I am still at the same point. Any other thoughts?
Ah but the point is that I have over 600 AP's to keep track of and over 2000 switches. It would be nice to have 1 console to be able to look at and see if a device is up or down. Not 1 for switches and another for AP's
