Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm planning to setup an NFS server to send the MARS archives to. I have a MARS 100e and I need to keep the archives for up to one year, so I plan on keeping the archives on the NFS server for at least two or three months before backing them up to t...
Hello,I'm trying to configure a Syamantec Anti-Virus server with my local CS-MARS controller. I'm following the configuration guide @ http://www.cisco.com/en/US/products/ps6241/products_user_guide_chapter09186a00804f711a.html#wp1033094 but I cannot ...
When I configure a keepalive type as the ap-kal-ssl script, the keepalive fails. I found that the servers being monitored are prompting with a certificate warning (see attachment) informing me that the name on the cert does not match the name of the...
Is using a HTTP authentication keepalive script to monitor a web server that requires authentication the best method to use?Reference: CSS Advanced Configuration Guide - HTTP Authentication KeepaliveAny input on this subject is greatly appreciated!
Has anyone ever ran across what causes "Internal Rx Errors:"? I've noticed that this counter is increasing quite rapidly, after clearing the interface stats first of course. This is occuring on my uplink interfaces (e13 and e14) which are the gig i...
Did you ever find a solution?I'm using the LDAP/Active Directory, Group Policy, Attribute Map design (http://www.cisco.com/application/pdf/paws/98634/asa_ldap_group_pol.pdf) for my ssl vpn setup, but I'm encountering the same issue with the AnyConnec...
Well, I can only think of a couple of possible things you could check. Do you have the slash notation mask added to the end of your route statements? It should be entered as "Route Name" "Destination Network" and then "Gateway", for example: "Rout...
This is kind of a late reply, but if you are interested in my two cents; I've learned that with the WLC guest authentication you can have either SSL or HTTP enabled for the user authentication. If you have SSL enabled, the auth page defaults to the ...
Good to know you got yours working! I ran into a road block with mine because I want to run WEP-128 with one SSID and WPA2-PSK with AES-CCMP on the other SSID. I still have not figured out how to do this exactly. Someone mentioned in an earlier po...
