Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to figure out how/where the FXOS stores passwords (local users, radius key, ect...). I need to assess how they are stored to determine if organizational security policies are being met. Is anyone familiar with this subject that can provid...
I have a Firepower 2110 being managed by Firepower Management Center (FMC), both in firmware version 6.2.2. I've spent the last couple of days trying to configure a S2S VPN with an Azure "Virtual Network Gateway"to no success.
The available docum...
I am having a hard time trying to figure out which SFP or SFP+ that I need to purchase for a couple of 3750X that I have.There will be SMF ran between the two and I will be utilizing an existing fiber run. I am including two photo's I have of the fib...
I have ran into a routing problem that I think should be simple but for some reason I am unable to think my way through it. I have provided a simple depiction of my network in the attached image.
Quick back story on the network that can probably b...
I have a point to point connection with an off-site location that we recently upgraded our bandwidth from 100 to 500 Mbps. I had a 2901s on both sides and discovered that 167 Mbps was the max throughput we could achieve.
I recently migrated the routi...
I now have the VPN connection established. I didn't validate the actual address associated with one of the network objects I was using on the FTD side.
I can confirm that it is possible to use an FTD device (managed by FMC) to establish an IPSec S...
! Sample ASA configuration for connecting to Azure VPN gateway!! Tested hardware: ASA 5505! Tested version: ASA version 9.2(4)!! Replace the following place holders with your actual values:! - Interface names - default are "outside" and "inside"! - <...
Mark / Jon, thank you for your input, it is greatly appreciated. I am going to lean towards Marks suggestion.
I believe something like this should work?
RTR C Config:
track 8 ip sla 1 rechability!ip sla 1 icmp-echo 10.255.0.1 threshold 3000 timeout...
Joseph, The 167 came from the cisco documentation. I was seeing sustainable speeds of around 105 with two 2901s. When I replaced one side with the 3750G, I noticed a push closer to 120 Mbps. These are sustainable speeds, I have noticed spikes up clos...
