Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've gotten stuck with a new script I'm creating. As part of it, I would like to pull the list of nodes that are in the fabric and then use that list to do other tasks. I have not been able to find the correct method to get the list of nodes. Foll...
"The maximum amount of time that an archive should be continuously marked as event data before event marking is disabled. The value should be entered in seconds and the range of values is between (1-86400). The default is 2 hours (7200 seconds). "Can...
I'm looking for a few suggestions on known working video cards. Accroding to the specs listed in: http://www.cisco.com/en/US/docs/security/physical_security/video_surveillance/network/vsm/client/VsmWorkstationBaselineSpec.pdfThe card listed is the N...
I need to run rapid spanning tree on a catalyst 6500 with a single instance across all vlans. How can this be done? My edge device does not support 802.1s.
I'm trying to setup rapid spanning tree between a pair of 6500's and an HP Procurve 4100. The HP switch only uses one instance of S/T across all vlans, whereas it looks like the Cat by default uses 1 instance per vlan. Is there a way to set the Cat...
Holly, can you please clarify this with the 2 hour activity window? What happens if there IS activity over that defined window, and when are the files tagged for activity? Is it only after the stop event and only if the stop event happened within ...
I had a similar issue with some 5011 cameras I was working on at my desk. I didn't troubleshoot it much, but there appears to be something going on if the same switch port is used and different cameras are tried 1 after the other. Since I had a sw...
According to HP support, the ProCurve switches only support single instance spanning tree. I have not seen any config options that would lead me to think otherwise.
I would have to argue your point here. I am not looking for anything other than what is advertised on the AP. I am just looking for it to work properly. On the Cisco Services/System Config Page there are 2 buttons. 1 is for "Reset All System Fact...
I would like to add a bit more info. I found the :resetall command, and this works for the test unit at my desk. This option is not available from telnet, only through serial. I am looking for a solution that I can do remotely such that I will not...
