Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everybody,I need your feedback for etherchannel and cross-stack etherchannel.In fact, we use cross stack etherchannel between our SAN and two stacked 3750G. We also have the same topology between our Cisco 4400 WLC and two stacked 3750G.Our proble...
Hi everybody!I've a problem with my WLC. On the first web page ( Monitor -> Summary ), the clients summary is correct.But if I go to Monitor -> 802.11b/g and then click on detail for any AP it report an invalid user count ( sometimes 190 users associ...
Hello,I've recently migred all of my AP to LWAPP+ WLC.I think that WCS server is very bad for monitoring (no good summary, no associated client per AP etc....) and want to continu e to monitor my AP via cacti. My questions are the following :1. Is it...
Hello,I use a cisco 4404 & ACS 4.1I've no L2 security. I use an external Web auth page.My question is the following:How to verify the SSId that the user use to login WITHOUT L2 security (802.1X)?I've set the allow AAA overide for each SSID.I've tried...
Hi,I use an ACS 3.3 and simply want to delete lot of user (~860) from the Cisco Secure Database. Is there a solution to delete all users from a group? I've not found this option. Thank you for your answer.
You right My question was about 6500 and 3750G. I've actually not implemented it this is why I've asked these question. You've answer to these question.Actually I've already implemented cross-stack etherchannel between 3750 and server/appliances and...
Thank again for your answer.My problem is always the same, no error showed by the cli, but if I use the Cisco Network Assistant I can see lot of discarded packet because they're too small.Do you have some cross-stack etherchannel with appliance or se...
Thank for your answer anandanarayana.Do you have made an etherchannel between a 6500 and just one 3750G or an stack of 3750G with port of both switch in the etherchannel?
Hello,I've the same problem with my VPN concentrator. I rsolved the problem with givig the domain before the username.For exemple username: mydomain/myusernamepassword: mypasswordHope that help... How do you have configure it with you WLC?Vincent
