Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I noticed this bizarre behaviour and wondered if anyone has encountered this before and know why this is happeneing.The scenario is as follows:|R1|-LAN[12.12.12.0/24]-|R2|-WAN[23.23.23.0/30]-|R3|-WAN[34.34.34.0/30-|R4|Each router has a loopback ad...
Hi,It's ok to use the tunnel source as loopback0. The only caveat is that each router must be able to route to the loopback 0 of the other router.Quick test: from cisco2811 [192.168.1.254] do the following: ping ip 80.32.xxx.125 source loopback0IF th...
Hi,Firstly it looks ti me like your PIM is not working properly, because you have no pim neighbours. Firstly, let's see if your tunnels work. On Cisco2811[loop 2.2.2.2]: ping 10.10.1.2 & ping 10.10.2.2
Hi,Here's a link to help with the description of active and passive FTP:http://www.cisco.com/web/about/ac123/ac147/ac174/ac199/about_cisco_ipj_archive_article09186a00800c85a7.html
Hi,In the absence of the configs for the other 2800 I have a few questions/tips, which might help you:I assume you have pim enabled tunnels on the other Cisco 2811 routers with loopback0 as the source and multicast globally configured [ip multicast-r...
