Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi We are getting reports from Cisco Works that one of the interfaces on the router is getting InputPacketErrorPct 18%. I have tried chafing the cable (just incase). Any idea's what I could try next?
Hi Giuseppe,We have a HUB that does full duplex or so it says on the interface that are connected. Even if it isn't it for a 15min test it should only throw up a few erros shouldn't it?I'll have a look at port mirroring as well.J
Thanks for your help with this Jorge.A bit more info. The interface connects to a 2800 router then from that to the internet. We used to go straight out onto the internet, then the people who matter decided to put in a "demarcation point" (2800 route...
Thanks for the reply.The output of our interface is: FastEthernet2/1 is up, line protocol is up Hardware is i82543 (Livengood), address is 0009.7bcd.b439 (bia 0009.7bcd.b439) Description: TEST INT - DO NOT USE!!! Internet address is xxx.xxx.xxx.xx...
