Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloCan someone help me explain the output of sh spanning-tree int gi 1/2I have an output here which is confusing interface GigabitEthernet1/2
no switchport trunk native vlan tag
switchport private-vlan host-association 958 2958
switchport mode priv...
we have a setup 6500-------> 2970Not much traffic on a trunk but we have quite a lot of input drops on 2970but the input drops dissapears if i disable keepalivescan someone help me out with this ?6506 interface :interface FastEthernet3/15 switchport ...
Can someone kindly explain the details of the command:we want to know why out low bank utilisation is high in ACL_TCAMand one way to determine is to check the features on the interface done by sh fm fie int po31.100
Interface Po31.100:
Feature intera...
We have a site to site vpn tunnel for different offices and we usually use taacs for username and password and we want to give privilege level access to few people. and access to only few commands in privilege mode using the same tacacs password ,, ...
Is there any command or procedure where we can put on cmts( ubr 7246vxr) link coming from netwrk serice provider which established a thrshold on the traffic on that link and generate a trap or log ?would cable downstream rate limit acheive that..Thn...
Thanx for getting back to me SwetaThe thing is there is no traffic passing through the interface so there should not be any input Queue and there should not be any input drops and the input drops dissappear when i disable keepalives.By default keepa...
I made some reasrch too : Yes your right . There is not direct approach or any document which explains which feature uses which bank.FM and Fie are responsible to determine an alogirthm based on the configurations in the switch.In our case as we have...
Hello Richard,Thank you so much for your reply.I uploaded the output of the sh fm fie int command but its hard to understand the outputHow can we determine which bank to use and what is it using now from the outputWhy do we have huge low bank utiliz...
I just replied to a post yesterday on 3750s,,i think you can use same commands on 3560 also :On 3750s :Rate limiting is not supported by 3750, but policing is:One way to do egress rate-limiting is using: 'srr-queue bandwidth limit' command.For e.g...
