Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a C420M3 standalone server with a Cisco (LSI) 9271-8i RAID controller. Server and RAID controller is updated with the latest Server Firmware.Via the RAID WebGUI, I see that all of the Advanced Software Options are installed (i.e. FastPa...
Hello,I have the following topology: CUCM <-----H.323------> Gateway (ISR3845) <------SIP------> ViaTalk (SIP Provider)When I make an outbound call, I dial the phone number, and then there's just silence until the party answers the phone, at whic...
Hello,The datasheets indicate that the 39xx series ISR G2 routers support AES, but they don't indicate if they handle both AES128 and AES256 in hardware. Via our account manager, we've heard that they only support AES128 in hardware, but not AES256....
Hello,I've been using IPv4 with ZBFW for some time, and it's worked pretty well. But, all that's all been with IPv4. I'm now trying to connect to Hurricane Electric's (HE.NET) IPv6 Tunnel Broker, and am having issues. I have my own /48 from HE.NET...
Arun,Thank you for your prompt response.I tried the "voice call send-alert" earlie today, and there was no change. I have not tried the "voip rtp send-recv".Additionally, I found this posting that sounds similar to what I'm experiencing, and I am i...
Mocah,I've been trying to get my tunnel up with HE.net for quite some time, but without luck. Have you made any progress in getting your ZBFW working with HE's TunnelBroker?
