Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have several 2811s before me. They each have VPN module, VWIC-1MFT-T1 channelized T1 and WIC-1DSU-T1-V2 WICs. I booted one and the WIC-1DSU-T1 does not appear at bootup time in console output. The VWIC does appear, as you can see below. I thought, ...
I have several Catalyst 2950s that were somehow erased. They do not boot, there is no IOS image in the flash..I need to reload the IOS on it, and as far as I can tell all I can do in this case is Xmodem transfer.I read the procedure here:http://www.c...
Well, this is hard to understand. As Leo says the HWIC is supported. But here it seems to say those same slots support WICs: http://www.cisco.com/c/en/us/products/collateral/routers/2800-series-integrated-services-routers-isr/prod_qas0900aecd80169b...
Aaron,The target system isn't broken, it's just not on site. I have suggested we set one up here. That has met with lukewarm response. Heh. Is there an easy way to put new firmware on these phones without the CUCM being on site? We have all local ip...
Aaron,Yeah, created a zombie. My bad. Shoot for the headcrabs. It seems that address books are stored on 7940s, which I am much more familiar with. Well, AFAICT. My surprise they are not on 7941s. Or so you say. However I have missed, received and...
As I re-resurrect this old thread. Heh.I have some 7941s that need to be moved from one network to another. I read this procedure, and tried it on two phones, both say "upgrade" now. The 7940s I have are resettable without having to reload the phone...
The most famous were always Shiva and Nortel/Bay Networks. The world is full of those. They are everywhere, still running. Even though both of those manufacturers are gone.3Com, IBM, Perle also had some.WTI seems to still be in business. Incredible...
