About santi8809

santi8809 · 12-14-2023

Hi,I am having this situation on an Interface connected to a VMware Host, where internally is configured a VMSwitch for MGMT.Sending 1000, 100-byte ICMP Echos to 172.X.X.200, timeout is 2 seconds:!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!...

santi8809 · 12-18-2023

#show plat hardware fed switch active qos queue stats internal cpu policerCPU Queue Statistics============================================================================================(default) (set) Queue QueueQId PlcIdx Queue Name Enabled Rate Ra...

santi8809 · 12-15-2023

sh int te1/0/2TenGigabitEthernet1/0/2 is up, line protocol is up (connected)Hardware is Ten Gigabit Ethernet, address is cc36.cf29.0002 (bia cc36.cf29.0002)Description: Uplink-HV1-Vmnic7MTU 1500 bytes, BW 10000000 Kbit/sec, DLY 10 usec,reliability 25...

santi8809 · 12-15-2023

#Show controllers cpu-interfacequeue retrieved dropped invalid hol-block-------------------------------------------------------------------------Routing Protocol 1253 0 0 0L2 Protocol 65759 0 0 0sw forwarding 103 0 0 0broadcast 214611 0 0 0icmp gen 0...

santi8809 · 12-15-2023

#show policy-map control-planeControl PlaneService-policy input: system-cpp-policyClass-map: system-cpp-police-ios-routing (match-any)0 packets, 0 bytes5 minute offered rate 0000 bps, drop rate 0000 bpsMatch: nonepolice:rate 13000 pps, burst 3173 pac...

santi8809 · 12-14-2023

post this output : show interface te1/0/6ML-SW-HIVM-01#sh int te1/0/6TenGigabitEthernet1/0/6 is up, line protocol is up (connected)Hardware is Ten Gigabit Ethernet, address is cc36.cf29.0006 (bia cc36.cf29.0006)Description: Uplink-HV2-Vmnic2MTU 1500 ...

Member Since	‎12-14-2023 12:08 PM
Date Last Visited	‎12-21-2023 01:54 PM
Posts	8

User Statistics

User Activity

Packet Loss pattern 9300 to VMnic

Re: Packet Loss pattern 9300 to VMnic

Re: Packet Loss pattern 9300 to VMnic

Re: Packet Loss pattern 9300 to VMnic

Re: Packet Loss pattern 9300 to VMnic

Re: Packet Loss pattern 9300 to VMnic