post this output : show interface te1/0/6
ML-SW-HIVM-01#sh int te1/0/6
TenGigabitEthernet1/0/6 is up, line protocol is up (connected)
Hardware is Ten Gigabit Ethernet, address is cc36.cf29.0006 (bia cc36.cf29.0006)
Description: Uplink-HV2-Vmnic2
MTU 1500 bytes, BW 10000000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 10Gb/s, media type is 100/1000/2.5G/5G/10GBaseTX
input flow-control is on, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:12, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 16000 bits/sec, 17 packets/sec
5597 packets input, 716370 bytes, 0 no buffer
Received 1061 broadcasts (1048 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 1048 multicast, 0 pause input
0 input packets with dribble condition detected
415121 packets output, 129100928 bytes, 0 underruns
Output 201126 broadcasts (135054 multicasts)
0 output errors, 0 collisions, 2 interface resets
1048 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
ML-SW-HIVM-01#
ML-SW-HIVM-01#
what vlan exsi and vm host belong to ? 50
what is the outcome from esxi IP address to host sitting inside Linux box ? I am not getting this
