Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,My eyes are crossed from reading so many docs on QOS. I have a Cisco 2811 running CME, 10x1 connection to the Internet, SIP trunks to Callcentric running g729r8 and g711ulaw. Phones are 7960's running SCCP. Runs well except when someone is d...
Hello,I've inherited a Cisco Call Manager Express system at a local school. All the classrooms have phones, but they are only allowed to call internal extensions and 911.The teachers would like to be able to call parents after the school day ends at...
Hello,Have inherited an ASA5510 and need some assistance. Just had an NEC VOIP phone system installed and we have a single IP phone that is going to a remote site that needs UDP access through the ASA public IP > a pair of internal IP's based on por...
Hello,I have a 2811 with CME and CUE voicemail, and about 4 months ago voicemail quit working. I've rebooted but cannot dial up the extension, no audio response. I didn't think much of it, and we don't have the call volume where it's a big deal, bu...
Hello,I've had a SonicWALL to SonicWALL VPN up and running for a few years, with network 192.168.5.x at my office able to access 192.168.6.x and 192.168.70.x at my datacenter. Now the SonicWALL at my office needs to be replaced with a 2811, and I ne...
Reading your description I am assuming this is single location deployment and all traffic is local and directly to the internetYesif so unless you misconfigured your LAN QoSThat's just it, I haven't configured it at all, don't know how. there is prob...
I travelled to the site and shut down the router and pulled the voicemail module. It is an NME-CUE V4 with a 120GB SATA 2.5" hard drive and a flash card. When the router reboots, the EN light and the CF light come on, the SYS light on the card is g...
service-module Integrated-service-module 1/0 sessionTrying 172.16.2.1, 2066... OpenThen nothing after that. The IP of the module is 172.16.2.2 and I can't ping it from the LAN or from the 2800 router console.
