Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello guys
i have DMVPN phase 1 with EIGRP there are 2 hubs and 20 spokes.
i want to use MPLS from ISP X, as i know they will make VRF for me and my traffic will move through.
i am interested is it possible to use my current DMVPN phase 1 with EIGRP...
hello
I have ASA 5525 and i create on it access rule to permit ping from 172.16.10.10 to 172.16.20.10
im pinging 172.16.20.10 from 172.16.10.10 with -t
now i want to deny ping. i modified this access rule to deny ping.
but ping wasnot interrupted au...
helloI have dmvpn phase 1, with 2 hubs, 20 spokes and eigrp, HUB1 is main and HUB2 is backup. if HUB1 is down all traffic from spokes goes to HUB2 immediately in seconds, but when HUB1 comes up traffic from spokes automatically goes back to HUB1 afte...
Rick
yes it is hub and spoke, from both hubs (MAIN & DR) i have vti tunnels to each branch,
goal is to prevent branches from knowing each others subnets.
BRANCH-1
tunnel1
description %to MAIN%
ip address 1.1.1.69 255.255.255.252
tunnel2
description %...
hello I have tested today and only one spoke was late i have debug nhrp packet output from SPOKE:NHRP: Send Registration Request via Tunnel20 vrf 0, packet size: 108(F) afn: IPv4(1), type: IP(800), hop: 255, ver: 1shtl: 4(NSAP), sstl: 0(NSAP)pktsz: ...
hi re775it isn't problem of routing because as i remember dmvpn was down and unstable, yesterday i added on all routers next commands: crypto isakmp keepalive 10 3 periodiccrypto isakmp invalid-spi-recovery and tested, everything was fine i'm plann...