Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Please try "ip ospf network point-to-multipoint" on all the hub and spoke routers.
Also, it would be helpful if you can post the ipsec portion of the config (minus any security info).
Best of luck with your setup.
Hi From my experience, where I have encountered the error "%CRYPTO-4-RECVD_PKT_INV_SPI", it was due to "nhrp" stuck in IKE state.This error i encounter after 'flipping' traffic from hub-a to hub-b and/or with a primary hub is 'no-longer' available fo...
Hi George,I can think of two possible event that would explain the behavior you're experiencing.a) DMVPN state change.b) Change in the routing table.You can troubleshoot each of the above issue to identify which one is causing the problem, and then ...
