Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi There,Was wondering if someone has come across this before.I'm polling a couple very limited SNMP OIDs (ifHCInOctets/ifHCOutOctets of some interfaces) at high intervals on Catalyst 9300 class switches.At 5s, the ifHCInOctets/ifHCOutOctets is very ...
Hi Community:We have a WLC setup here with high traffic.With a general understanding of how CAPWAP traffic flows, should the In and Out of its interface be equal??I'm asking because it's close but about 10% off.TIA, Alex
Hi. I'm new here.I'm trying to run a Cisco-signed application "Bind9" on a C9300 and am following their guide:"Application Hosting on Cisco Catalyst Switches": https://developer.cisco.com/docs/app-hosting/general-instructions/The info seems thin on r...
We have many sites, all with the same SSID.When Apple macOS laptops join this one problematic site, it's failing to obtain an IP unless rebooted. Looking at a packet capture taken from a laptop, it sends an 'DHCP Request' to renew its invalid/previou...
I'm hoping someone has seen this DHCP issue.A user at location Walnut acquires an IP from an MX250 no problem, but when visiting location HS (also with a MX250), they can authenticate/associate, but no IP unless they reboot... A packet reveals the vi...
Thank you Gentlemen.M02@rt37 Very insightful to think about the device's agent reading the switch interface counters at a fixed interval, and the super high poll rate make these strangeness at 5 and 6 seconds obvious to the `snmpget`.Bringing the rat...
Here are two graphs.THe first is core to FW and shows the normal asymmetry per usual.The second graph shows the WLC traffic andhow in/out are basically equal -- but off a bit.
Thanks @Stefan Mihajlov for the tip. ` no app-hosting verification` doesn't see to exist anymore in 17.15 -- what tab completion gives is `no app-hosting signed-verification` which didn't change much. `show app-hosting infra` report then reported `IO...
Thanks. Interesting since we currently use "WPA + WPA2", and I understand WPA as utilizing TKIP, but it's not listed, although WPA2/AES is enabled. We are comfortable with changing it to "WPA2 + WPA3" under the Security/Layer2 options.I am very curio...
