Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to configure IPv6 packet inspection on a 2911 router (IOS 15.1(2)T5) but I'm unable to inspect router-generated traffic. There isn't an option "ipv6 inspect name xxxx udp router-traffic" as in IPv4. Thus I'm unable to ping from the router ...
Hello, I'm trying to configure phone encryption on CME 8.6 but the phones do not get registered.
I've tried the following guides, both without success:
http://www.firewall.cx/cisco-technical-knowledgebase/cisco-voice/956-cisco-voice-cme-secure-voip.h...
Hello, I'm having trouble to configure a voip trunk between two routers running CME. Can anyone help me please?I have the following scenario:[Analog phone ext 2923]----[PBX]----(FXO)[2911 CME-B]-----[2811 CME-A]-----[VoIP phone ext 3103]I've configur...
Hi salmandhunna1, thanks for your reply!
The dhcp network mask and telephony-service ip source-address are correct.
How can I check if the phone port has ISE configs?
Sorry, I forgot to mention it, dial-peer 2900 and 2901 have the same configuration except the port. dial-peer 2900 is port 0/1/0 and 2901 port 0/1/1. (just corrected my previous post)
But anyway, I solved the problem by disabling supervisory disconne...
Thanks for your reply, but still not working with acampbell's configuration.
My config is as as following:
"CME-A"
dial-peer voice 2900 voip destination-pattern 29.. session target ipv4:10.10.0.127 incoming called-number . dtmf-relay h245-alphanumeri...
Hello,I'm trying to configure a SIP trunk between CME and a SPA3000. Calls from the analog phone to VoIP (SIP and SCCP) are working perfectly, but I'm unable to call from the VoIP phones to the PSTN connected on SPA3000.How have you configured the SP...
