Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I was hired to clean up a network and document the topology and confgiuration. In the environment, there are a pair of Cisco 1900 series ISRs that are configured for HSRP and I'm having some difficulty figuring out why the HSRP is configured the w...
Hi,Recently my company purchased a Polycom "RealPresence® Group 500" video conferencing system for use at 3 remote offices. A reseller installed and is configuring the system.The 3 offices are behind Cisco 881W routers performing PAT on the LAN side....
Hi,I have a switch 2960S with a device attached to port gi2/0/26.Using an ACL I'd like to:a) Limit the device to only talk to one web server.b) Allow ssh traffic to the device from one subnet.So far I have:Extended IP access list 110 10 permit tcp...
Hi,Cisco ASA 5520, ASDM 6.2I have a remote access IPSEC tunnel group set up and am able to get connected from the Cisco client OK.I would however like to use our internal DHCP server to supply config info to the client (IP, WINS, DNS etc).I am a litt...
Awesome...thanks JonThis seems counterintuitive to me though...it looks like the source address is 10.0.8.200 port 22 but when I think about it, the source should be subnet 192.168.5.0 port 22.Could you offer an explanation?Thanks againM
Thanks for the reply.So do I understand then that this is a global setting? That is, I can't toggle DHCP, local pool, AAA assignment on a per Tunnel Group or Group Policy basis?Also is there a place in ASDM to set this?ThanksM
