Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I purchased a Cisco ISR 1111x-8p router for my business, but I did not know I needed to purchase a WIFI card with it to provide WIFI coverage for my building. Now I am stuck with a router that does not provide WIFI capabilities. My question is, can I...
I'm trying to enable MAC Address Filtering on my Cisco ISR 1111x-8p and I can't seem to get it working correctly. I tried adding my PC to the port-security list and removing it, but my PC is still connected to the internet. Is this the best way to ma...
I purchased a Cisco ISR c1111-8p router a week ago, it took me a week to configure the thing to connect to the internet and only after @balaji.bandi helped me out. I am in need of some guidance on what kind of VPN connections I should create for abou...
I bought a Cisco ISR c1111-8p for my company to start the journey to CMMC compliance, and I cannot get this thing configured at all. I am brand new to Cisco and the CLI, but over the last few days I have learned enough. I have been searching Google a...
@liviu.gheorghe Awesome! Just to be clear again, I can control WIFI access to the Asus WIFI network THROUGH the Cisco ISR 1100 router interfaces via port-security or ACL or whatever. So if I setup DHCP in the 192.168.1.x range for all computers in t...
If MAC filtering only works on WIFI then I will have to find another way to whitelist access to the router. I guess I could assign static IP's to the devices I need to connect to the router, then setup an ACL to only allow those static IP's.
@balaji.bandi I have updated my network diagram to show my Windows 10 PC, it's connected to the Cisco router via ethernet on GigabitEthernet 0/1/0. Here is the output to my mac address-table show command:Mac Address Tablecisco#show port-security inte...
@MHM Cisco World Here is my port-security show command output:cisco#show port-security interface gig 0/1/0Port Security : EnabledPort Status : Secure-upViolation Mode : RestrictAging Time : 1 minsMaximum MAC Addresses : 50Total MAC Addresses : 1Conf...
I was able to remove the MAC addresses from the interface, but can you tell me why my PC is still connected to the internet when I have MAC Filtering enabled but there are no MAC addresses being allowed? It should only connect to the internet if I ad...
