Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We need to establish a P2P link between 2 DC and I am wondering what are pros and con of connecting P2P link on either router or Switch and what is the best practice.Can someone please advice?
we had a power failure and after that ISR 4331 is not getting boot up with below error%ERROR% Memory Init Failure!Check that a Memory DIMM is populated in slot 0.we already changed the Memory to Slot 1, but still same error
Hi All,We are redesigning the Management of of offices network devices.network is like belowVlan 300-----SW--10.1.1.1----------10.1.1.2 Router----WANwe will configure reverse static router for 192.168.1.0/24 in router.Option 1- User separate manageme...
New switch is having a boot loader version Version 17.9.1r and IOS Version 17.6.4Current stack switch has Boot Loader Version 17.8.1r and IOS Version 17.6.4I have below questions in mind1. Can I add new switch to stack even though both have differe...
Hi All,I need clarification on traffic passing through Mobility tunnel between Foreign and Anchor controller.DHCP\Authentication\Switching is all Central. Once any traffic like radius\DHCP\DNS\Data traffic will reach Foreign WLC it will go to Anchor...
load sharing is main concern, we want traffic from DC1 (SW)----BGP---DC2(SW)- to land at Switch at DC2 and form switch we can load share traffic to DC2 WAN1 or WAN 2.DC1 (SW)----BGP---DC2(SW)---WAN1 or WAN2
I want when my switches goes down, then also I can access of routers on loopbackI am just trying to figure out what can be issue with below config in production environment? RTR--10.1.1.1-------------10.1.1.2 SWT01RTR01int loopbackip addresss 192.16...
