Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone,I'm curious if anyone here has installed any 1310 series bridges in outdoor harsh environments and how your antenna's held up. By harsh I mean very high level of vibration, dust, harsh winter weather etc. If anyone has any stories go...
I have a customer who has two offices, both have two Internet feeds. The problem is, both Internet feeds are from the same ISP, on the same subnet. My customer wants to load balance traffic out both Internet links, but, i'm a little stuck how I can...
My main concern now with 802.11 is deploying wirless into critical systems environments. Does anyone know the real risks of denial of service against 802.11b and g, and the effects of flodding a 2.4Ghz range? I ask this because I have a few custome...
Have a question about routing with a PIX. I have 4 branches with all PIX 515E's. This is in full mesh VPN topology. My question is, can I add a failover route through another branch if one link fails? I'm curious if i'm going to have to enable OS...
I know with the Restricted PIX, you can only have a max of 3 Interfaces. Does anyone know if this applies to the DMZ bundle? I want to know if I can add an additional FE port the a DMZ R bundle and have 4 active interfaces. Any help would be great...
Hi Rick,Sorry about that, I had myself confused with another issue I am working on. Ignore the default-gateway command all together ;). I appreciate your help, thanks!!!
Looks like maybe you didn't define traffic NOT to be translated on one end of your tunnel. Do you have all your access-lists and nat translations setup properly?
Hi Rick,So, say I enable cef, and use: ip default-gateway 0.0.0.0 0.0.0.0 x.x.x.a ip default-gateway 0.0.0.0 0.0.0.0 x.x.x.bThis will load share over both? Would this configure the links in a fail-over fashion? If it does load balance, how does it ...
Hi Rick,I can do this? How does the router know which default route to send to? Will it load-share across both? Can I direct my VPN tunnel to take say 200.2 and all other internet traffic to go to 200.1??Thks