Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys
Did someone encounter any issue with Cisco C9200L specifically assigning Static IP
I already set static IP in the local webUI and it can reach Meraki Dashboard however for quite some time
It will go back in being DHCP
Im not having issues wit...
Hi,Can someone guide me on how to replace a failed MX450 in HA?The scenario is we have 2 MX450 in HA. Recently, the primary had an issue and the secondary (warm spare) takes over.I'm just worried that if we try to replace the primary, the configurati...
Hi Experts,Do you have any idea why 1 port of C9300X gets suspended when configured using LACP protocol?In MS210-48, I just bundled port 49 and 50 wherein I confirmed that AGGR/0 is created.Configuration of C9300X is pretty basic.int range twe 1/0/1,...
Hi to all,Just want to ask if it's possible to access Meraki AP local status page via wired?I'm using poe injector so that I can connect directly using a laptop but currently unable to access.Tried to statically assign IP in my laptop and access 10.1...
Hi everyone,Just want to ask if there is a way to manually assign switch number in a stacking Meraki Switches (say 3 switches)?When I tried it before, there is no settings like this.Regards,Mike
Hi @Rasmus Hoffmann Birkelund ,Thank you for the response.Once the primary is powered down, I need to disable the HA settings, right?In this case, the configuration is intact in the secondary.Then, I need to re-enable HA and choose the new MX as warm...
I just noticed also that Meraki login page is new, not sure when the update came in.I hope it didn't add up to the missing aggregation configuration that I made during the time I'm configuring the switches
Hi @joey.debra , @Brash , @martin-lystad ,Thank you very much for all your inputs in this case.I managed to resolve the problem.Basically, most of the "aggregation" that I configured in Meraki Dashboard isn't there when I checked the settings yesterd...
Hi @martin-lystad ,Thank you for the response.This is the exact procedure that we made.Have the MS connect to internet using port 52 then configure 49-50 as aggregate.Wait for around 30 mins, then change the connection by removing port 52 and use 49-...
Hi @Brash ,Thank you for the response.I'm pretty sure that it is cabled and configured correctly.That's why I'm scratching my head on this issue Maybe I can try some debugs on C9300X tomorrow when I'm onsite.
