Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
With Cisco's End-of-Life for Mobility Express and the 1815i access points, I began to look for upgrade options and decided on the Cisco Catalyst 9105axi. These are End-of-Sale I believe, but great deal on Amazon for a NEW Cisco -ax capable AP.Here i...
Hello,I have an SR520 installed (along with several other Cisco products) and use the ADSL version. This has been a rock solid product, working without fail for over 3 years. I have periodically updated as new IOS releases have come out, and I want...
I previously posted about the inability to get a DHCP address from the LAN port of the SR 520. I have set up another older laptop (I needed the serial port) and opened a session via the CLI. The <show run> command yields a configuration file that l...
Thanks @Mark Elsen, I added a note to my post to make that clear. Since the download is free on Cisco.com, the critical dates are end of maintenance support and end of security patches. More important is the support contract for the HW...just in cas...
JeffMartin09424 and others on this thread, I had the same issue when upgrading to an RV345P from an RV340. I also have Cisco 2800's and 1815's in the network with Cisco's Mobility Express.The error message comes every 40 seconds or so, and looking a...
Thanks, This is helpful. I looking through the table, It appears that the image I currently have on the 2802i AP Is 8.2.110.0, but for AP software, I would need 15.3(3)JE.
However, if I understand the table, I could also update the 2802i to the ...
Hello Sreejth,
It appears that I have the same issue as another user you helped out. I have the 1815i's in a network running the Mobility Express, and I attempted to have the 2802i join as an AP. It appears to connect to the controller but is not...
