Hello All,
I have created 3 vlans and I have assigned it to the interface in Cisco SG300. The internet is working if manual ip is assigned and not via DHCP. I have configured the ip pool but DHCP is not getting released. If there is a proper set ...
Hello, I have configured multiple VLANs in a Cisco Catalyst 3750. This L3 switch is also acting as the DHCP source. I would like to know where can I find the DHCP logs in a this Cisco catalyst L3 switch? So I can direct it to a server where I ca...
Hello Kris,
* The firewall IP is 10.x.x.x
* I have created vlan, 200, 300, 400 in Cisco SG 300 and assigned to the interfaces.
* I have created a trunk with access to all the vlans to the trunk port connected to the fi...
Hi,
I am having a similar issue. The wan IP of the ISP is 111.93.***.*** /30. The gateway is 111.93.***.***. There are are six usable LAN ips starting from 111.93.245.144/29. The primary DNS is 103.8.46.5 and the secondary DNS is 103.8.44.5. I hav...
Hi, Thank you for your detailed explaination. Here if it is just the DHCP I can switch to pfsense in no time. But the main issue here is the number of VLANs configured. More than 20 VLANS are configured in the L3 switch. I think I will have to find a...
In pfsense firewall System Logs on the DHCP Tab, displays messages and events from the DHCP Daemon and the DHCP client for WANs.Each DHCP request and reply from DHCP clients is shown here, along with events and errors. IP addresses, MAC addresses, an...