Hi, if you are looking to change the MTU size of a link, do you have to do this at the same time for all connections along a path between a source and destination? In this case the source and destination are within the same AS.Thanks
Hello, I'm not sure if someone has come across this before. But they might enlighten me. Under what circumstances would you see ARP enteries on a switch for subnets out side of the local subnet?Example 2 switches back to back everything in defa...
Local would be between the router and on site CSU/NTU.Remote is via the telco network.Depending on which part of the world your in the CSU/NTU is the demarc point of the Telco.HTH
config tint serial xload-interval 30Default is 300 seconds or 5 minsUsing show int serial x you should be able to see load on the interface at 30 second intevals.Check load i.e 255/255 is using 100% 125/255 is 50% utilization.BTWA tool you could look...
Hi, loop back testing can be done to check a leased line for faults.A local loop would be either a software or hard loop on the NTU/Modem/Martis node in your premises.Useful for checking your local cable and router interface.A remote loop is the sa...
I'd agree with show log.You could also try sh int fax (see line 7 "Last input")Same for serial links also.FastEthernet0/x is down, line protocol is down Hardware is Fast Ethernet, address is 0030.1942.d458 (bia 0030.1942.d458) MTU 1500 bytes, BW 0 ...