Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have tried to install MPLS VPNV6 between different MPLS PE I can see the routes inside the VRF and also the next-hope is reachable but I can’t ping between two VRFs in two different PEsPE1# ping vrf ABC ipv6 2002:172:9::10 source 2002:172:9:...
Hi,I have configured VPLS bgp signaling between ASR & Junos the VPLS connection from Junos side indicate it’s up without any problem but from ASR side it’s down The following output form Junos & ASRRP/0/RSP0/CPU0:IGW-LON-1#show l2vpn bridge-domain b...
Dear ,I’m trying to configure INTER-AS VPLS as the attached topology the ASBR1:Cisco IOS , PE1:ASR9K and ASBR2:Juniper MXThe L2vpn BGP Multi-hope BGP is up and I can see the label swapping form the both end but the VC is down RP/0/RSP0/CPU0:IGW-LON-1...
Hi Nagendra but in this case you will have MPLS 6VPE technology if u enable IPV4 in VPNV6 , but I think the 6VPE technology u used it incase u don't have full IPV6 connection in your core but in my case I have full connection IPV6 BGP unicast is thi...
Hi ,I will share my experience in this Due to my requirements to have Mnulti-hope L2 vpn signaling between ASBR2 and PE1 I used this RFC option C http://tools.ietf.org/html/rfc4761#section-3.4ASBR1: Junos MXASBR2:Cisco 7600( you can’t run VPLS BGP ...
