Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I need to enter in rommon to change the confreg because I cannot use "conf t" in the actual configuration.I tried during booting to press "Break" from Putty terminal but is not able to run into rommon.My intention was to check the following lin...
Hello,I've an VPLS between N540 XR 7.2.2 and Juniper.On both sides MTU is 2000, but i still get mismatch and PWs are down.ACs: 1 (1 up), VFIs: 1, PWs: 3 (0 up), PBBs: 0 (0 up), VNIs: 0 (0 up)pw-id 551, state: down, Static MAC addresses: 0pw-id 551, s...
Hello,
Please let me know if following configuration is correct:
The request is:
Platinum AF46/EF 0%Gold AF41 60%Silver AF31 20%Bronz NOMARK 20%
Therefore:class-map match-any VOIPmatch dscp efclass-map match-any AppSharematch dscp af31class-map match...
Hello,
On Cisco 7600, I've the following commmand:
bfd interval 750 min_rx 500 multiplier 4 - on interface.
Now the service should be migrated to NCS540 with XR, how can be this translated because I don't have option "interval".
Thank you!
Hello,
In order to get MTU 2000, a subinterface which is configured with 'rewrite ingress tag pop 1 symmetric' needs to be configured as 2018 MTU, and if configured with 'rewrite ingress tag translate 1-to-1 dot1q 555 symmetric' needs only 14 overhea...
Hello,Below from Cisco very hidden:If authentication of passwords is performed on RADIUS or TACACS+ servers, the passwords assigned touser level 7 and user level 15 must be configured on the external server and associated with the $enable7$and $enabl...
"Authorization failed" once I try to enter in "conf t". This is because some tacacs configuration that was added, something was missing don't know, even is tacacs then local configured.There should be a backup way for cases like this, that's why I wa...
